Note that DTS-HD can output audio at up to 96 kHz sampling rates, but DTS-HD Master Audio can output 5.1 at up to 192 kHz. DTS-HD master Audio also has a dramatic range where it can be encoded at a variable rate below 1 Mbps all the way up to around 24.5 Mbps.
'Surround Sound' conservation since 2011! Welcome to DTS by J4J From the tab above you can check out the 'Surround Sound List' for a wide variety of 5.1 DTS CD upmixes, plus 5.1, 4.1 and 4.0 DTS CD conversions from past to present. The whole point is to trick them to output 5.1 PCM which then gets picked up by DTS connect (or interactive or whatever) and compressed for S/PDIF and your receiver. If you're using HDMI for audio, everything goes out as PCM so you just pick from the speaker icon what format you want, 2.0, 4.0, 5.1, 7.1, whatever. DTS-HD Master Audio™ is a premium 5.1/7.1 high-definition audio codec that is bit-for-bit identical to the studio master. DTS- HD DTS- HD digital surround audio decoder with output up to 5.1 channels for streaming file-based and disc-based DTS-encoded media featuring adaptive streaming for smoothing streaming bandwidth fluctuations.
DTS stands for Digital Theater Systems. While Dolby Digitalis the standard 5.1 digital surround format on all DVD players, DTS is becominga possible alternative. DTS, first introduced in the movie Jurassic Park
DTSAudio CDor
How To Configure And Test 5.1 Surround Sound On Windows 10 ...
5.1 Music Discis an audioCompact Discthat contains music surroundsoundconfigurations.The specification permits discrete channel configurations - 2.0 (L, R) to 6.1 (L, R, C, LFE, Ls, Rs,Cs), although 5.1 (L, R, C, LFE, Ls, Rs. Physically, a DTS Audio CD conforms totheRed Bookstandard;however a DTS bitstream, is actually encapsulated in each PCM audio track. Thisconfiguration permits any non-DTS enabled player to output multi-channel audiowhen connected to an external DTS-compliant processor (e.g. a typical AVreceiver) via a digital interface like S/PDIF or HDMI, provided that the playerdoes not modify the bitstream internally.Although the DTS audio track is read at the same fixedbitrate as 16-bit linear PCM (1,411 kbit/s) only 14 bits(1,234 kbit/s) are used for the encoded data stream; the remaining twobits are always zeros. This has the effect of attenuating the noise that wouldresult (by roughly 12 dB) should one attempt to play a DTS Music Disc witha non-DTS system, and thereby reducing the chance of speaker damage. Howeverthis is a non-issue for players with internal DTS decoders, such as someDVD-Audio and Blu-ray players; these devices will output a properly decodedaudio signal through their analogue ports.
Although all compliant DTS decoders support surroundconfigurations of up to 5.1 channels, a DTS ES decoder must be used to fullydecode discs with 6.0 or 6.1 channels of audio. DTS ES comes in twoflavors: DTS ES Matrix and DTS ES Discrete. Depending on the disc and decoderused the Cs (center surround) channel will either be derived from the Ls and Rsof a conventional 5.1 track via matrix decoding, or exist as a fully discretedigital extension to a 5.0 or 5.1 core. In either case, backward compatibilityis maintained with non-ES decoders.
Dts 5.1 Surround Sound
SPDIF (Sony/Phillips DigitalInterconnect Format) - digital audio interface. SPDIF was first used only totransmit stereo 16-bit PCM data (CD player was the only source of digitalaudio). It is very straightforward: audio samples are transmitted at constantfrequency, one-by-one (and bit-by-bit) in 32-bit blocks where 8 bits are usedfor synchronization and some side info and 24 bits are used for sample. In mostcases, only 16-bit transmission is supported (CD carries only 16-bit sound) andlow 8 bits of a sample are always zeroed. This interface is very simple andcheap and so it became widespread.
Therefore, when multi-channel soundera came to home theaters, SPDIF was an ideal candidate for digital interfaceto transmit multi-channel sound. However, it is a problem: current interfaceimplementations work only with stereo sound, but now it is required to transmitup to 6 channels (or 8 channels at present). It was decided not to change theinterface but to transmit compressed multi-channel sound instead of PCM data(for digital interface it does not matter what to transmit). So receiver mustrecognize compressed data and decode it. For this purpose a new standard wasintroduced (IEC 61937) that describes how compressed data must be transmittedand how receivers can distinguish PCM and compressed data.
PCM data transmission mode and
Unless noted we well use SPDIFtransmission, SPDIF output mode and SPDIF stream terms only for encoded streamsafterwards.
Compressed data may be transmittedover SPDIF instead of PCM data. Therefore, we can prepare a CD disk and placecompressed AC3 or DTS data instead of usual PCM tracks. When we playback thisdisk with a CD player connected to a receiver we will get true multi-channelsound!
But this trick does not work with analog connection andportable CD players: we will get terribly loud noise instead of nice music.Because of this CD disks with AC3/DTS tracks are relatively rare.When a mediaplayer tries to playback a multi-channel disk it does not know that it containscompressed data. It's just because it is no simple method to distinguish usualand multi-channel disks. We have to read some data from the disk and have somemethod to know what kind of data we got. Hardware receivers have a specialdetection circuit, but software media players (most of it) have no. That's thepoint why media player cannot playback such discs right even when some AC3 orDTS decoder is installed.DTS CDsare encoded in 5.1 surround sound using the DTS compression algorithm. As such,the fidelity is of lower quality than the sound quality offered by CDs,DVD-Audio discs, and SACDs. DTS CDs are not encoded in stereo. We can play DTSCDs in three ways:
- On a CD playerconnected to a 5.1-channel receiver or pre/pro with a DTS decoder via an optical or coaxial digital cable.
- On a DVD-Video player with the 'DTS Digital Out' logo on the frontpanel (meaning any player available today) to a 5.1-channel receiver or pre/prowith a DTS decoder via an optical or coaxial digital cable.
- On a DVD-Videoplayer with a built-in DTS decoder connected to a 5.1-channel receiver orpre/pro via the 5.1-channel outputs (i.e., six RCA cables).- On a DVD-Video player with the 'DTS Digital Out' logo on the frontpanel (meaning any player available today) to a 5.1-channel receiver or pre/prowith a DTS decoder via an optical or coaxial digital cable.
SONY DVD COMBO Players:
Dts 5.1 Music Download
200120022003200420052006200720082009201120142015AlternativeAlternative RockAmbientAudio-DVDBluesClassicalClassical MusicCountryCountry FolkDTS 5.1DTS 5.1 musicDVD-AudioElectronicFolkHard RockHi-Res 24 bitJazzMetalNew AgePopProgressiveProgressive RockRockSACD ISOSACD-RSoulVAVocal
Dts 5.1 Sound Card
All materials on the site are provided for informational purposes only. After reading, remove the material and purchase licensed version